16 | English
1 609 929 X24 | (18.8.10) Bosch Power Tools
– Press the spindle lock 35 until it engages and
tighten hexagon bolt 40 in anticlockwise di-
rection.
– Tilt the retracting blade guard 6 down, until
cover 38 can be fastened again (tighten
screw 37).
Operation
f Before any work on the machine itself, pull
the mains plug.
Transport Safety (see figure D)
The transport safety-lock 34 enables easier han-
dling of the machine when transporting to vari-
ous working locations.
Releasing the Machine (Working Position)
– Push the tool arm by the handle 3 down a
little in order to relieve the transport safety-
lock 34.
– Pull the transport safety-lock 34 all the way
outward and turn it by 90°. Allow the trans-
port safety-lock to engage in this position.
– Guide the tool arm slowly upward.
Securing the Machine (Transport Position)
– Loosen the locking screw 31 if tightened.
Pull the tool arm completely to the front and
tighten the locking screw again.
– Screw the adjusting screw 22 of the depth
stop completely upward. (see “Adjusting the
Depth Stop”, page 19)
– To lock the saw table 7, tighten the locking
knob 10.
– Pull the transport safety-lock 34 all the way
outward and turn it by 90°. Allow the trans-
port safety-lock to engage in this position.
– Push the locking lever 4 and at the same time
lower the tool arm via handle 3 until the
transport safety-lock engages in the end po-
sition.
The tool arm is now securely locked for trans-
port.
Preparing for Operation
Extending the Fence (see figure G)
For bevel angles, the fence extensions 27 must
be moved.
– Loosen locking screw 28 and completely pull
out the fence extension 27.
– Retighten the screw again.
Extending the Saw Table (see figure F)
Long workpieces must be underlaid or support-
ed at their free end.
The saw table can be extended left or right with
the saw-table extensions 13.
– Loosen locking screw 32.
– Pull out saw-table extension 13 to the de-
sired length (max. 290 mm).
– Retighten the screw again.
Clamping the Workpiece (see figure G)
To ensure optimum working safety, the work-
piece must always be firmly clamped.
Do not saw workpieces that are too small to
clamp.
– Press the workpiece firmly against the
fence 15.
– Insert the material clamp 17 provided into
one of the holes 33 intended for it.
– Tighten fastening screw 29.
– Loosen locking screw 43 and adjust the
material clamp to the workpiece. Retighten
the locking screw again.
– Firmly clamp the workpiece by turning the
threaded rod 44 in clockwise direction.
– To release the material clamp, turn the
threaded rod 44 in anticlockwise direction.
OBJ_BUCH-1304-001.book Page 16 Wednesday, August 18, 2010 10:12 AM
To Next Page
Loading...
