29
Operation
Charging the control computer
NOTICE: Without charging the internal rechargeable battery
again, the data and time will remain saved for a maximum of
6 months. After being switched back on, the date and the time
of the Nyon control computer will automatically be reset after
successful GPS location.
• Charge the control computer at least every 6 months.
On the e-bike
1. Insert a full rechargeable battery in the e-bike
(see chapter “Operation > Rechargeable battery”).
2. Insert the control computer in the holder (see chapter
“Operation > Control computer > Insertion and removal”).
3. Use the
button on the rechargeable battery to switch the
e-bike on.
Via USB
1. Open the cover. (see Figure B-10).
2. Use a USB 2.0 cable to connect the USB jack of the control
computer to a commercially available USB charger or the
USB port on a computer.
“USB connected” will appear in the text display field.
• If you switch the Nyon control computer off during the charging
process, pull the USB plug before you switch the Nyon control
computer on.
USB port
Cover
Fig.: B-10 USB port with cover on the right side of the control
computer.
To Next Page
Loading...
Need help?
General
