English | 23
Bosch Power Tools 1 609 929 L54 | (18.2.08)
Filling in Spray Material (see figures B1–B2)
f Before any work on the machine itself, pull
the mains plug.
– Unscrew the container 11 from the spray
gun.
– Turn the suction tube 10 so that the spray
material can be sprayed with almost no resi-
due:
– Fill the spray material into the container and
screw the container firmly to the spray gun.
Starting Operation
f Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
f Pay attention that the power tool cannot
draw in dust or other contamination during
operation.
Switching On
– Plug the mains plug into a socket outlet.
– Grasp the power tool and point it at the
spray surface.
The power tool is equipped with a two-step trig-
ger switch 16. The first step starts the turbine.
The second step transports the spraying materi-
al.
– Pull the trigger switch 16 until spraying ma-
terial starts to come out.
Switching Off
– Release the trigger switch 16.
– Pull the mains plug from the socket outlet.
Working Advice
Spraying (see figures C–D)
Note: Observe the wind direction when operat-
ing the power tool outdoors.
– Firstly, carry out a test-spray run and adjust
the spray pattern and the spray material
quantity according to the spray material. (For
adjustments, see the following sections)
– Make sure to hold the spray gun vertical to
the spray object at a uniform clearance be-
tween 5
– 15 cm.
– Begin the spraying procedure outside the tar-
get area.
– Move the spray gun evenly cross-wise or up-
and-down, depending on the spray pattern
setting.
An even surface quality is achieved when the
paths overlap by 4
– 5cm.
– Avoid interruptions inside the target area.
An even movement of the spray gun results in an
even surface quality.
Non-uniform clearance and spray angle lead to
heavy formation of paint mist and thus to an un-
even surface.
– End the spraying procedure outside the tar-
get area.
Never spray the container completely empty.
When the suction tube no longer immerses in
the spray material, the spray jet will break off,
resulting in a non-uniform surface.
When coating material builds up on the nozzle
and air cap, clean both parts with the corre-
sponding solvent.
Note: Only place down the power tool on a level
and clean surface so that it can not tip over.
For spray jobs on
horizontal surfaces
/objects
toward the front in
nozzle direction
For spray jobs
overhead
toward the rear in
handle direction
OBJ_BUCH-670-001.book Page 23 Monday, February 18, 2008 2:16 PM
To Next Page
Loading...
