To Next PageTo Next Page
Need help?Do you have a question about the Bosch PFZ 700 PE and is the answer not in the manual?
General| Power | 710 W |
|---|---|
| Weight | 3.1 kg |
| Cutting Depth in Steel | 10 mm |
| Stroke Length | 20 mm |
| Stroke Rate | 500 - 2600 spm |
Read all safety warnings and instructions. Failure to follow may result in electric shock, fire and/or serious injury.
Keep work area clean and well lit. Do not operate in explosive atmospheres. Keep children and bystanders away.
Ensure correct plugs match outlets. Avoid body contact with earthed surfaces. Do not expose to rain or wet conditions. Do not abuse the cord.
Stay alert, watch what you are doing. Use personal protective equipment. Prevent unintentional starting. Do not overreach. Dress properly.
Do not force the power tool. Use the correct tool for your application. Do not use if switch is faulty.
Hold by insulated surfaces. Keep hands away from sawing range. Apply machine to workpiece when switched on.
Ensure footplate faces workpiece. Use sharp blades. Do not brake blade with side pressure. Clamp material well.
Disconnect power before work. Wear gloves. Ensure blade holder is clean. Check tight seating.
Four settings for optimal adaptation of cutting speed, capacity, and pattern. Set with rotary switch 7.
Observe mains voltage. Press On/Off switch to start. Use lock-on button for continuous operation.
Stepless control via On/Off switch pressure. Preset with thumbwheel 4. Reduce rate for plastic/aluminium.
