9
Power manager
The power manager limits the maximum power consumption of
the appliance to 2900 watts.
If you switch on a hotplate and the power limit is reached,
appears briefly on the heat setting display. The appliance is
automatically regulated to the highest heat setting which is still
possible.
Automatic time limit
If a hotplate has been switched on for a long time without the
setting being changed, the automatic time limit is activated.
The hotplate stops heating.
” ‰ and the •/œ residual heat
indicator flash alternately on the hotplate display.
The display goes out when you touch any control. You can
make new settings.
When the time limit is activated depends on the heat setting
selected (1 to 10 hours).
Wipe protection
If you wipe over the control panel while the hob is switched on,
settings may be altered.
To prevent this from happening, your hob has a control panel
pause function. Touch the
- D symbol. A signal sounds and
the display light above the
- Dsymbol lights up. The control
panel is locked for 30 seconds. You can now wipe over the
control panel without altering any settings.
Note: The main switch is excluded from the control panel
pause function. You can switch off the hob at any time.
Energy consumption display
You can use this function to have the total energy consumption
between switching the hob on and off displayed.
Once switched off, the energy consumption in kilowatt hours
(e.g. 1.08 kWh) is displayed for 10 seconds
The accuracy of the display depends, amongst other things, on
the voltage quality of the power supply.
The display has not been activated. You can find out how to
activate the display in the Basic settings section.
N:K
To Next Page
Loading...
