English - 2
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety instructions in the
enclosed booklet must be fol-
lowed.
Before using for the first time,
ask for a practical demonstra-
tion.
If the mains cable is damaged or
cut through while working, do not
touch the cable but immediately
pull the mains plug. Never use the
machine with a damaged cable.
Wear ear protection.
Wear safety goggles.
■ Never allow children to use the machine.
■ For long hair, wear hair protection. Work only
with closely fitting clothes.
■ When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
■ Always direct the cable to the rear away from
the machine.
■ Insert the mains plug only when the machine is
switched off.
■ Before any work on the machine itself, pull the
mains plug.
■ Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Use only
extension cables that are approved for outdoor
use.
■ The machine must be operated only with the
appertaining protective devices.
■ The swinging protective guard 7 must be able
to move freely and close on its own accord; it
must not be clamped whilst it is open.
■ Always use the riving knife 6.
■ For stationary use, the machine may be oper-
ated only on a sawing table with restarting pro-
tection.
■ Apply the machine to the workpiece only when
switched on.
■ Clamp the workpiece if it does not remain sta-
tionary due to its own weight.
■ When working, always guide the machine
away from the body.
■ Do not work with materials containing asbes-
tos.
■ The cutting path must be free of obstacles both
above and below.
■ The saw blade must not protrude more
than 3 mm out of the work piece.
■ Keep hands clear of the rotating saw blade. Do
not come into contact with the rotating saw
blade on the underside of the workpiece.
■ Do not allow fingers to enter the sawdust ejec-
tor 2.
■ Do not saw into nails, screws, etc.
■ Do not work overhead with the machine.
■ The saw blade and riving knife must not be-
come stuck in the cut. The saw tooth offset
must be wider and the main body of the saw
blade thinner than the thickness of the riving
knife.
■ Protect saw blades against shocks and im-
pacts.
■ Do not tilt the saw blade.
■ If the saw blade jams, switch off the machine
immediately.
■ The spindle locking button 12 may be actuated
only when the saw blade is at a standstill.
■ After switching off, do not slow down the saw
blade by exerting side pressure.
■ Always switch off the machine and allow to
come to a stop before placing it down.
■ Use only sharp, flawless saw blades. Change
any cracked, bent or dull saw blades immedi-
ately.
■ Saw blades of highly alloyed, high-speed steel
must not be used.
■ Bosch is only able to ensure perfect function-
ing of the machine if the original accessories
intended for it are used.
For Your Safety
PKS 54/66 Euro - Buch Seite 2 Dienstag, 17. Juni 2003 9:13 09
15 • 1 609 929 B67 • 03.06
mikosoft praha s.r.o.
mikosoft praha s.r.o.
mikosoft praha s.r.o.
mikosoft praha s.r.o.
To Next Page
Loading...
