English - 4
The cutting mark 0° ( 18) indicates the position of
the saw blade for right angle cuts.
The cutting mark 45° ( 17) indicates the position
of the saw blade for 45° cuts.
Both cutting marks include the width of the saw
blade. Always guide the saw blade off of the
drawn-up cutting line, so that the required meas-
ure is not reduced by the width of the saw blade.
For this, choose the corresponding notch side of
the cutting mark 0° ( 18) or 45° ( 17), as shown in
the illustration.
Note: It is best to carry out a trial cut.
Check for correct mains voltage: The voltage
of the power source must agree with the voltage
specified on the nameplate of the machine.
Equipment marked with 230 V can also be con-
nected to 220 V.
Switching on:
Actuate the switch lock 1.
Press the On/Off switch 10 and hold pressed.
For safety reasons the On/Off switch of
the machine cannot be locked; it must
remain pressed during the entire opera-
tion.
Switching off:
Release the On/Off switch 10.
Speed Selection (Type CE)
With the adjustment knob 9, the speed can be
continuously selected. The required speed is de-
pendent on the saw blade used and the material
to be worked (see Saw Blade Table).
Constant Electronics (Type CE)
The constant electronics ensures that the ma-
chine speed is the same regardless of the load
conditions; this ensures uniform work advancing
and a smooth cutting pattern.
Overload Protection (Type CE)
When the machine is overloaded while sawing,
the motor stops and starts again only when the
advancing rate is reduced.
Gradual, smooth starting procedure
(Type CE)
Due to the gradual, smooth starting procedure of
the machine, a 13 A fuse is sufficient.
■ Before any work on the machine itself, pull
the mains plug.
■ Wear protective gloves.
■ The saw blades used must correspond to
the characteristic data in these operating
instructions.
■ Use only saw blades with an allowable
speed matching at least the no-load speed
of the machine.
For changing the tool, it is easiest to stand the
machine on the front end of the motor housing.
Removing
Press spindle locking button 12 and keep de-
pressed.
■ The spindle locking button 12 may be actu-
ated only when the saw blade is at a stand-
still.
Using the Allen key 13 unscrew the clamping
bolt 22.
Remove clamping flange 21.
Pivot back the swinging protective guard 7 and
hold firmly.
Remove the saw blade.
Cutting Marks
Initial Operation
0°45°
0°45°
Changing the Tool
A
A
PKS 54/66 Euro - Buch Seite 4 Dienstag, 17. Juni 2003 9:13 09
17 • 1 609 929 B67 • 03.06
mikosoft praha s.r.o.
mikosoft praha s.r.o.
mikosoft praha s.r.o.
mikosoft praha s.r.o.
To Next Page
Loading...
