-14-
part and should be inspected
periodically for wear. If the drive belt
shows signs of drying out, cracking or
tearing, it should be replaced. If the
drive belt will not track properly or
comes off the pulleys, it should be
replaced.
Installing new drive belt: Loosen screw
and remove the drive belt cover (Fig.
11). Cut and remove the worn drive
belt. Before installing the new drive
belt, clean both pulleys thoroughly. First
place the new drive belt onto the drive
pulley then rotate clockwise while
pushing the belt onto the driven pulley
(Fig. 12). Reinstall the drive belt cover
and securely tighten screw (Fig. 11).
Fig. 12
DRIVEN
PULLEY
DRIVE
PULLEY
DRIVE
BELT
If an extension cord
is necessary, a cord
with adequate size conductors that is
capable of carrying the current
necessary for your tool must be used.
This will prevent excessive voltage drop,
loss of power or overheating. Grounded
tools must use 3-wire extension cords
that have 3-prong plugs and receptacles.
NOTE: The smaller the gauge number,
the higher the cord capacity.
RECOMMENDED SIZES OF EXTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
Extension Cords
Accessories and Attachments
Tool’s
Ampere
Rating
Cord Size in A.W.G. Wire Sizes in mm
2
C
ord Length in Feet
C
ord Length in Meters
25 50 100 150 15 30 60 120
3-6
6-8
8-10
10-12
12-16
18
18
18
16
14
16
16
16
16
12
16
14
14
14
–
14
12
12
12
–
0.75
0.75
0.75
1.0
–
0.75
1.0
1.0
2.5
–
1.5
2.5
2.5
4.0
–
2.5
4.0
4.0
–
–
The use of any other attachments or acces so ries not specified in
this manual may create a hazard.
Store accessories in a dry and temperate environment to avoid corrosion and
deterioration.
Description Included Sold Separately
Accessories
Blade wrench 2.5mm ● ●
Woodrazor reversible micro-grain tungsten carbide blade ● ●
Attachments
PA1207 Standard guide fence – ●
Dual-mount guide fence with plastic overshoe – ●
Vacuum hose adapters – ●
Vacuum hoses – ●
Shavings bag – ●
PA1209 3-degree bevel overshoe for dual-mount fence – ●
Maintenance
To Next Page
Loading...
