Bosch Professional GLM40 - 9.6.2 Subtracting values; 9.7 Changing the unit of measurement; 9.8 Switching sound on;off

English | 31
Subtracting values
To subtract values, press the button (3) [–]. The subsequent steps are the same as for
the section on adding values.
Changing the unit of measurement
The default unit of measurement is "m" (metres).
Switch on the measuring tool.
Press and hold button (4)[Func] until "

" and "mft" flash on the display. "0.000m" is
shown at the bottom of the display.
Press the button (6)[+] or the button (3)[–] to change the unit of
measure. "0.000ft" is shown at the bottom of the display.
Press the button (6)[+] or the button (3)[–] to change the unit of
measure again. "0'00"" is shown at the bottom of the display.
To exit the menu item, press the measuring button (2)[ ] or the on/off button (5) [ ].
The selected setting remains saved after you switch off the measuring tool.
Switching sound on/off
The sound is switched on by default.
Switch on the measuring tool.
Press and hold button (4)[Func] until "

" and "mft" flash on the
display. "0.000m" is shown at the bottom of the display.
Bosch Power Tools 1 609 92A 5DX | (27.01.2020)