7
en
Cleaning and servicing
■ Place a bowl or plate under the outlet
opening.
■ Insert the mains plug.
■ Switch appliance on with the On/Off
button.
■ Place the food to be processed in the
filling tray.
■ Only use the pusher when adding more
ingredients.
Application instructions:
If the food to be chopped up jams in the
worm gear: Use reverse button to remove
the blockage.
1. Switch appliance off with the On/Off
button.
2. Wait until the drive comes to a standstill.
3. Briefly press reverse button.
4. Wait until the drive comes to a standstill.
5. Switch appliance on with the On/Off
button.
After using the appliance:
■ Switch appliance off with the On/Off
button.
■ Remove mains plug.
■ Pull out the pusher.
■ Remove filling tray.
■ Remove the mincer attachment. Holding
down the release button, turn the
attachment to the right and remove.
■ Disassemble mincer attachment.
■ Clean all parts, see “Cleaning and
servicing”.
Cleaning and servicing
Important information
The appliance requires no maintenance.
Thorough cleaning protects the appliance
from damage and keeps it functional.
W Electric shock risk
– Never immerse the base unit in liquids
and do not clean in the dishwasher.
– Before cleaning the appliance, pull out
the mains plug!
Warning!
Do not use abrasive cleaning agents.
Surfaces may be damaged. Do not clean
the aluminium parts (housing, worm gear
and threaded ring of the mincer attachment)
in the dishwasher. Harmless discolouration
may occur over time.
Cleaning the appliance
■ Pull out the mains plug.
■ Wipe the mincer clean with a damp
cloth. If required, use a little detergent.
Cleaning the attachments
■ Rinse housing, worm gear and threaded
ring of the mincer attachment by hand.
■ Dry metal parts straight away and apply
a little edible oil to protect them from
rust.
■ Fig. G gives an overview of how to
clean the individual parts.
Troubleshooting
Fault
Appliance stops but does not switch off.
Cause
Appliance overloaded, e.g. mincer blocked.
Remedial action
■ Switch appliance off and wait until it
comes to a standstill.
■ Press reverse button to remove the
blockage.
■ Wait until the drive comes to a standstill.
■ Switch on appliance again.
Fault
Appliance switches off during use.
Cause
Appliance overloaded. Overload protection
feature has been activated.
Remedial action
■ Switch off the appliance.
■ Remove mains plug.
■ Leave the appliance to cool down for
approx. 60 minutes.
■ Lift appliance and press the thermal
circuit breaker on the underside of the
appliance (Fig. A, 14).
To Next Page
Loading...
