Bosch PRP6A6D70R - User Manual

Other manuals for Bosch PRP6A6D70R

Questions and Answers

A
Andrea LoweSep 1, 2025
What to do if the pump for the intelligent dosing system on my Bosch Washer/Dryer is blocked?
- X
  xschultzSep 1, 2025
  To address a blocked pump in the intelligent dosing system of your Bosch Washer/Dryer: First, put the appliance into standby mode. Then, clean the pump unit. Switch the appliance on. If the display appears again after cleaning the pump unit, or the programme cannot be started, call customer service.
K
Kevin LeeSep 12, 2025
What does 'OVERLOAD SCALE' or 'UNDERLOAD SCALE' mean on my Bosch Kitchen Appliances?
- J
  Jessica DudleySep 12, 2025
  If your Bosch Kitchen Appliance displays 'OVERLOAD SCALE' or 'UNDERLOAD SCALE', it means the measurement is outside the scale's range (-990 g to 5000 g). Do not add more than 5000 g or remove more than 990 g of ingredients.
N
nhuangAug 30, 2025
Why is my Bosch Washer/Dryer water pressure low?
- B
  Brandon LopezAug 30, 2025
  Low water pressure in your Bosch Washer/Dryer could be due to a few reasons. Try cleaning the water inflow filter. Also, make sure that the tap is turned on and that the water inlet hose is not kinked or jammed.
T
Tiffany ChaseSep 14, 2025
What to do if my Bosch Kitchen Appliance switches off during use?
- S
  sullivanrobertSep 14, 2025
  Your Bosch Kitchen Appliance might be switching off during use due to several reasons: * Too much food being processed at once or for too long. To resolve this, turn the rotary switch to 'y', disconnect the mains plug, reduce the processing quantity, and allow the appliance to cool down to room temperature. * The swivel arm was opened. To fix this, turn the rotary switch to 'y', press the release button, and push the swivel arm down until it locks into place. * The bowl or bevel gear (accessory) has become loose. To correct this, turn the rotary switch to 'y', disconnect the mains plug, tighten the bowl by turning it until it stops, and tighten the bevel gear and close the locking lever completely.
C
Christopher ShortSep 13, 2025
What to do if SensorControl Plus on my Bosch Kitchen Appliances cannot be started?
- J
  Jordan BriggsSep 14, 2025
  If SensorControl Plus on your Bosch Kitchen Appliance cannot be started and shows “ADD INGREDIENTS” even after adding them, it means the ingredients were added before the scales were activated. Empty the bowl, reselect the program, and only add ingredients after the program is selected and the scales display “0 g” or “0.00 lb” (depending on setting) or “ADD INGREDIENTS”.
B
Bobby RobertsSep 18, 2025
What to do if my Bosch Kitchen Appliance displays 'FOR SCALE STOP MACHINE'?
- E
  Elizabeth GillSep 18, 2025
  If your Bosch Kitchen Appliance displays 'FOR SCALE STOP MACHINE', it means the scale is switched on while the appliance is running. To resolve this, switch the appliance off and wait until it stops before using the scale.
D
dtylerSep 23, 2025
How to troubleshoot a Bosch Kitchen Appliance when nothing is shown on the display and the illuminated ring is off?
- H
  Haley ElliottSep 23, 2025
  If nothing is shown on the display and the illuminated ring is off, it means the appliance has no power supply. Check the power supply by plugging the mains plug into the mains.
C
Corey WatersAug 27, 2025
Why Bosch Washer/Dryer spin result is not satisfactory?
- F
  fowlerjeffreyAug 27, 2025
  If the spin result of your Bosch Washer/Dryer isn't satisfactory and the laundry is too wet, it could be due to a blocked drain pipe or water outlet hose. Clean the drain pipe and the water outlet hose. Also, ensure that the drain pipe or water drain hose isn't caught or jammed. If the unbalanced load detection system has interrupted the spin cycle because the laundry is unevenly distributed, redistribute the laundry in the drum.
A
Ariana WeberAug 26, 2025
How to fix long drying times on my Bosch Washer/Dryer?
- C
  Christina GilesAug 26, 2025
  If your Bosch Washer/Dryer is taking too long to dry, it could be due to a few factors. If the ambient temperature is greater than 30 °C or there is insufficient air circulation at the appliance's installation location, ventilate the area. Also, if fluff has accumulated in the drum, run the Cottons 90°C programme without any laundry or detergent.
A
Ashlee BishopAug 25, 2025
What to do if the Bosch Washer/Dryer programme does not start?
- A
  Andre ToddAug 26, 2025
  If the programme on your Bosch Washer/Dryer isn't starting, make sure that you have pressed the start button. Also, check that the door is fully closed and that the childproof lock is deactivated. Ensure that the 'Finish in' option is not activated and that no laundry is caught in the door.

This document describes the Bosch Built-in Gas Hob, models PRP6A6D70, PRP6A6N70, and PRR7A6D70, providing essential information for its use, maintenance, and safety.

Function Description

The Bosch Built-in Gas Hob is designed for cooking purposes in private households and domestic environments. It features multiple gas burners with varying power outputs, controlled by individual knobs. The appliance includes an automatic ignition system for convenient startup. A key safety feature is the thermocouple, which interrupts gas flow if a burner accidentally goes out. Some models are equipped with a dual-wok multi-crown burner, allowing independent regulation of inner and outer flames for precise cooking. The hob also includes a main switch to lock the hob, preventing accidental ignition and allowing for quick shutdown of all burners.

Important Technical Specifications

The hob models feature different burner types with specific power outputs:

Economy burner: 1.10 kW
Standard-output burner: 1.90 kW
High-output burner: 2.80 kW
Dual-wok multi-crown burner: 4.00 / 4.20 kW

The control knobs allow for incremental flame height adjustment from power level 1 to 9. For dual-wok burners, specific power levels (e.g., 60, 4, 3, 10) regulate combinations of inner and outer flames. The appliance is designed for use up to an altitude of max. 2000 m above sea level. Product information according to (EU) 66/2014, including energy efficiency data, is available on the product page.

Usage Features

Control and Ignition:

Control Knobs: Used to configure all functions and set flame height. Press and turn anti-clockwise to ignite.
Automatic Ignition: Press and hold the control knob for the selected burner, turning it anti-clockwise to the highest level. Sparks are generated, and the flame ignites. Continue holding for a few seconds to activate the safety system.
Manual Ignition: In case of a power cut, burners can be lit manually by holding a lighter or flame against the burner while pressing and turning the control knob.
Switching Off: Turn the control knob clockwise to the "Off" position (O). A residual heat indicator (h or H) may appear in the display, indicating hot parts.
Main Switch: This switch interrupts the general gas flow. Pressing it locks the hob and switches off all active burners. To unlock, press and turn it fully clockwise.

Cookware:

Suitable Diameter: Use cookware with a base diameter appropriate for each burner to ensure efficiency and safety.
- Multi-crown burner: 22-30 cm
- High-output burner: 20-26 cm
- Standard-output burner: 14-22 cm
- Economy burner: 12-16 cm
Placement: Cookware should be placed correctly on the pan supports, centered on the burner. Never place cookware directly on the burner.
Dual-Wok Burner: Only use cookware with a rounded base on the multi-crown burner, along with the additional wok grid.
General Advice: Use cookware with a thick, flat base. Avoid deformed cookware. Cover saucepans with lids to save energy.

Cooking Settings:

The manual provides recommended power levels for various cooking tasks, from boiling water and deep-fat frying to simmering and melting.
Tips for energy-saving cooking include choosing appropriate burner sizes, covering pans, and using pressure cookers.

Safety:

Gas Leaks: Immediately shut off gas supply, extinguish flames, avoid electrical switches, open windows, and call service if gas is smelled.
Ventilation: Ensure adequate kitchen ventilation, especially during intensive or prolonged use of the gas hob, to manage heat, moisture, and combustion products.
Fire Risk: Never leave hot oil or fat unattended. Do not use water to extinguish grease fires; instead, cover with a lid or fire blanket. Keep flammable objects away from the hob.
Burns: Accessible parts become hot during operation. Keep small children away. Never heat empty cookware.
Hob Covers: Do not use hob covers.
Ignition Safety: If a burner does not ignite within 10 seconds, turn the control knob to "Off" and ventilate the room. Do not attempt to re-ignite for at least one minute.
Control Knob Issues: If a control knob is stiff or loose, contact after-sales service.
Glass Surface: In case of cracks or fractures in the glass, immediately switch off all burners and electrical heating elements, disconnect power, shut off gas, and contact customer service.

Maintenance Features

Cleaning:

General Cleaning: Allow the appliance to cool down. Clean with a sponge and soapy water, then dry with a soft cloth. Remove spilled liquids immediately to prevent food from sticking.
Burners: Clean burner parts after each use with a non-metallic brush and soapy water. Do not clean burner parts in a dishwasher. Ensure burner holes and grooves are clean for a correct flame.
Pan Supports: Allow to cool, then carefully remove and clean with a non-metallic brush and soapy water. Pay attention to rubber pads. Pan supports can also be cleaned in a dishwasher using recommended cleaning agents.
Ignition Plugs: Clean regularly with a small, non-metallic brush. Avoid heavy knocks.
Control Knobs: Do not remove control knobs while cleaning to prevent humidity damage to the appliance's interior.
Cleaning Products: Use suitable cleaning products; avoid harsh, abrasive detergents, steel wool, knives, sharp objects, or steam-cleaning appliances.

Troubleshooting:

The manual provides a troubleshooting guide for common malfunctions such as impaired electrical operation, automatic ignition not working, non-uniform burner flame, gas supply issues, burner switching off prematurely, and display errors.
Solutions include checking circuit breakers, connecting power, cleaning burner parts, and ensuring correct positioning of components.
For persistent issues or damaged components (e.g., power cord, gas lines), contact trained specialist staff or customer service.

Disposal:

Packaging: Packaging materials are environmentally compatible and recyclable. Sort individual components by type.
Old Appliance: Unplug, cut the power cord, and dispose of the appliance in an environmentally friendly manner. The appliance is labeled according to European Directive 2012/19/EU (WEEE) for proper return and recycling.

Customer Service:

Function-relevant genuine spare parts are available from Customer Service for at least 10 years.
Contact Customer Service for expert advice, problem resolution, or repairs. Provide the product number (E-Nr.) and production number (FD), found on the rating plate or appliance certificate.