Bosch PRS9A6D70A - Customer Service; Warranty Conditions

Customer service en
17
Any of the following are considered to be abnormal
operation and may require servicing:
■ Yellow tipping of the cooktop burner flame.
■ Sooting up of cooking utensils.
■ Burners not lighting properly.
Gas valves, which are difficult to turn in case the
appliance fails to operate correctly, contact the
authorised service provider in your area.
4Customer service
Cu s t o mer ser vi ce When contacting our Technical Assistance Service,
please provide the product number (E-Nr.) and
production number (FD) of the appliance. This
information is given on the specifications plate located
on the lower section of the hob and on the label in the
user manual.
After-sales contact details for all countries can be found
in the attached after-sales service directory.
Warranty conditions
In the unlikely event that the appliance is damaged or
does not meet your expectations in terms of quality,
please inform us as soon as possible. For the warranty
to be valid, the appliance must not have been tampered
with, or used inappropriately.
The applicable warranty conditions are those set out by
the company's representative office in the country of
purchase. Detailed information is available from retail
outlets. Proof of purchase must be presented to obtain
the benefits of the warranty.
We reserve the right to introduce changes.
The kitchen smells of gas. A gas tap has been left on. Turn off the taps.
Incorrect coupling of gas cylinder. Check that the coupling is sound.
Possible gas leak. Shut off the gas supply, ventilate the premises and imme-
diately notify an authorised installation technician to check
and certify the installation. Do not use the appliance until
ensuring that there is no gas leak in the installation or
appliance itself.
The burner immediately
switches off after releasing the
control knob.
The control knob was not held down for long enough. Once the burner is on, hold the control knob down a few
seconds longer.
The grooves on the burner are dirty. Clean the grooves on the burner.
Fault Possible cause Solution