en Troubleshooting
50
Fault Cause and troubleshooting
E:32-00 will light up
alternately or indicator
for water supply lights
up.
Water tap is jammed or furred up.
▶ Turn on the water tap.
The flow rate must be at least 10 l/min when the
water supply is open.
The filters in the water connection of the supply or
AquaStop hose are blocked.
1. Switch off the appliance.
2. Pull out the mains plug.
3. Turn off the water tap.
4. Unscrew the water connection.
5. Remove the filter from the inlet hose
6. Clean the filter.
7. Re-insert the filter in the inlet hose.
8. Screw the water connection back on.
9. Check the water connection for leaks.
10.Restore the power supply.
11.Switch the appliance on.
E:34-00 will light up
alternately.
Water is continuously running into the appliance.
1. Turn off the water tap.
2.
Call Customer Service →Page56.
E:61-02 will light up
alternately.
Not an appliance fault. Wastewater pump is blocked
or the cover of the wastewater pump is loose.
1. Clean the wastewater pump.
→"Clean wastewater pump", Page55
2. Secure the cover of the wastewater pump so it
clicks into position.
→"Clean wastewater pump", Page55
To Next Page
Loading...
Need help?
General
