Troubleshooting en
53
Fault Cause and troubleshooting
Remnants of food on
tableware.
Filters are inserted incorrectly and/or not engaged.
1. Insert the filters properly.
→"Filter system", Page47
2. Engage the filters.
Washing programme selected too weak.
▶ Select a more intensive washing programme.
→"Programmes", Page20
▶ Adjust the sensitivity of the sensors.
→"Sensors", Page12
Tableware has been precleaned too intensely. The
sensors chose a weaker programme. Stubborn soiling
cannot be entirely removed.
▶ Only remove large remnants of food and do not
prerinse tableware.
▶ Adjust the sensitivity of the sensors.
→"Sensors", Page12
Tall narrow receptacles in corner areas are not rinsed
adequately.
▶ Do not position tall narrow receptacles at too great
an angle or in corner areas.
Top baskets on right and left are not set to same
height.
▶ Set the upper basket on the left and right to the
same height.
→"Top basket", Page24
Removable streaks
are present on
glasses, glassware
with a metallic appear-
ance and cutlery.
Amount of rinse aid to be dispensed is set too high.
▶ Set the rinse aid system to a lower setting.
→"Setting the amount of rinse aid", Page31
No rinse aid has been added.
▶ Add rinse aid.
→"Adding rinse aid", Page30
Detergent residue is present in the final rinse. Lid of
the detergent dispenser is blocked by tableware items
and will not open fully.