Bosch PXY601JW1E/48 - Page 15

Assist en
15
15.1 Transfer settings
Requirement:Move the cookware to a cooking zone
which is not switched on, which you have not yet pre-
set and on which no other cookware has been previ-
ously placed.
1.
Move the cookware.
The cookware is detected. After a few seconds, the
option to confirm the default settings for the new
cooking zone appears on the display.
2.
Confirm the settings.
a The settings are transferred to the new cooking
zone.
Assist
16 Assist
The cooking assistant is guaranteed to make cooking
simple and it promises outstanding cooking results.
If you have selected the required temperature, the
sensors continuously measure the temperature of the
cookware and keep it constant during the cooking pro-
cess.
Advantages
¡ Once the selected temperature is reached, it auto-
matically keeps it constant, saving energy.
¡ The oil will not overheat and the food will not boil
over.
16.1 PerfectFry Sensor
Suitable for cooking or reducing sauces, pancakes or
frying eggs with butter, for frying vegetables or steaks
up to the required level of boiling, and for keeping the
temperature under control.
This function is available on all cooking zones marked
with this symbol ⁠.
Temperature levels
Temperature levels for preparing meals.
Level Temper-
ature
Functions
1 120ºC Boiling and reducing sauces, fry ve-
getables
2 140ºC Searing in olive oil or butter
3 160ºC Frying fish and coarse foods
4 180ºC Deep-fat frying breaded, frozen and
grilled food
5 215ºC High-temperature grill and griddle
plate
Recommended cookware
Special cookware has been developed for this function,
which delivers the best results.
The recommended cookware is available from cus-
tomer service, specialist retailers or our online shop
www.bosch-home.com.
Note:You can also use other cookware. Depending on
the composition of the cookware, the achieved temper-
ature may differ from the selected temperature level.
Switching on the PerfectFry Sensor
1.
Place empty cookware on the cooking zone.
2.
Select a cooking zone.
3.
Touch and select ⁠ PerfectFry Sensor.
4.
Select the required temperature level and touch
to return to the main screen.
a The function is switched on. The temperature level
and light up.
a The temperature display lights up increasingly red
until the required temperature level has been
reached. A signal then sounds.
5.
Add the frying fat and then the food to the frying
pan.
Switching off PerfectFry Sensor
1.
Select the cooking zone.
2.
Set to 0.
a The function is switched off.
3.
To exit the PerfectFry Sensor function, touch
and select a different cooking mode.
Recommendations for cooking with PerfectFry
Sensor
The following table shows the ideal temperature levels
for a selection of dishes. The temperature and the
cooking time depend on the amount, condition
and quality of the food.
Meat
Escalope 4 6-10
Escalope, breaded 4 6-10
Fillet 4 6-10
Chops 3 10-15
Cordon bleu, Wiener Schnitzel 4 10-15
Steak, rare, 3cm thick 5 6-8
Steak, medium, 3cm thick 5 8-12
Steak, well-done, 3cm thick 4 8-12
T-bone steak, rare, 4.5cm thick 5 10-15