Bosch Rexroth AG, RE 95206/08.2018
18 RC10-10 Series 31 | BODAS Controller
Dimensions
Dimensions [mm]
Dimensions
44
37.9
13.5
±1
146
85
196.6
54.3
95.7
98.9
241.2
142.3
±2.5
ø7
±0.3
8
±4
23.5
±4
181
±1
188
±1
203
±1
24.2
±1
59
±1
167.3
54.6
±1
132.7
24.4
±0.4
40
40.15
±1.5
a
b
d
c
Long-side view
Top view
Display without scale
Bottom view
Side view with pulled connector
Fixing:
▶ The BODAS controller must be fixed at
4 positions (a, b, c and d).
▶ The BODAS controller has to be fastened in the
vehicle so as to avoid bouncing against other
vehicle parts and additional fastening elements
of the controller.
▶ The maximum tightening moment for fastening
the BODAS controller with M6 screws is 10 Nm.
This tightening moment refers to a screw
connection without washer.
▶ If washers are used, the equivalent tightening
moment has to be determined.
▶ Rexroth’s consent is required if fixing is different
from above.
▶ The minimum gap between the bottom and the
screw on surface of the vehicle is 1 mm.
▶ Even surface of customers screw on surface
between the points a, b, c and d is
0.5
▶ The wiring harness must be supported
mechanically at the controller mounting position
(distance <150 mm) in a way that the excitation
of the ECU is in phase (e.g. at the ECU screw on
plate).
▶ The cable harness should be fixed such that the
assembly has sufficient room to exit the BODAS
controller without putting too much force on the
mating connector.
▶ If the mounting surface is not sufficiently even,
place flexible compensating elements between
the fixing points of the BODAS controller and
the mounting surface
Harness plug
mounted
Harness plug
not mounted
Label
Cover
DAE
PCE
To Next Page
Loading...
