Non-compliance with this safety instructions can result in moderate or minor
personal injury.
Non-compliance with this safety instructions can result in material damage.
Symbols
Symbol Meaning
Reference to supplementary documentation
This note gives important information, which must be observed.
Single, independent handling step
1.
2.
3.
numbered instruction:
The numbers show that the action steps must be taken one after the
other.
Warning against dangerous electric voltage
Warning against hot surfaces
Warning against rotating machine parts
Warning against overhead load
Electrostatic sensitive devices
Prohibition for persons with cardiac pacemaker
Do not carry along metal parts or clocks
Hammer scales are forbidden
ATEX-Logo; Explosion protection identification
The UL Recognized Component Mark identifies recognized compo‐
nent parts which are components of a bigger product or system
The letters “C” and “E” stand for “Communautes Européennes”. The
CE-marking expresses the conformity of a product with relevant EC-
regulations.
For MSK motors, conformity according to low-voltage directive
2014/35/EU, EN 60034-1, EN 60034-5.
Components for the use in systems for “integrated safety technique”
prepared.
Tab. 1-3: Meaning of symbols
2/57
About this documentation
MSK Synchronous Servomotors
Bosch Rexroth AG R911325169_Edition 03
To Next Page
Loading...
