17
B O S C H
* Model dependent
5 Release the “Calc’nClean” button, and
gently shake the iron for some seconds.
6 Repeat the steps 4 and 5 three times
until the tank is empty.
7 Then plug the iron in and heat it up
again until the remaining water has
evaporated.
Push the “Calc’nClean” button a few
times more to clean the valve.
8 Unplug the iron and let the soleplate
cool down. Wipe the soleplate with a
damp cotton cloth only.
C “Calc’nClean” with descaling liquid *
For deep descaling, it is recommended to
use the descaling liquid especially
developed by Bosch. This procedure
should be carried out every 3 months.
1. Unplug the iron from the mains socket.
2. Fill the water tank with tap water mixed
with a measure (25 ml) of the descaling
uid (19*).
3. Then follow the procedure described
above in section “Calc’nClean” (steps 2
to 8).
The descaling liquid may be purchased
from the customer service or specialist
shops.
Name of accessory: TDZ1101
D “
anti
-calc”
The “anti-calc” cartridge has been designed
to reduce the build-up of scale produced
during steam ironing, helping to extend the
useful life of your iron. Nevertheless the
“anti-calc” cartridge cannot prevent all of
the scale that is produced naturally over
time.
To Next Page
Loading...
