Operating the Dishwasher
Start the dishwasher:
1 Press the On/Off button.
2 One of the wash cycle LEDs will be flashing. You can now select a wash cycle.
3 Press the Cycle Select arrow buttons to select the desired wash cycle.
4 Press Start to begin the cycle.
Delay start:
1 Press the On/Off button.
2 Select a cycle.
3 Press and hold the Delay Start button until the desired delay time is shown in the display window or the
appropriate LED is lit (depending on model).
4 Press Start to begin the cycle.
Cancel a cycle:
1 Press and hold Start for 3 seconds.
2 Wait about i minute until the display reads "0:00" (models with display) or the "Clean" LED illuminates
(models without display), indicating it is done draining.
3 Press the On/Off button. You may now start a new cycle.
Child Lock:
1 After starting a cycle you can activate the Child Lock.
2 Press and hold the < button until the display reads "CL" (models with display) or the "Child Lock" LED illumi-
nates (models without display). Note: "CL" disappears from screen when button is released.
3 Child Lock is now active and buttons will not function, except On/Off.
4 To deactivate, press and hold the < button until the "Child Lock" LED turns off or "CL" disappears from the
display.
For models wit._ .hdisplay:
To enter options mode:
1 With the door closed, press the On/Off button to turn the unit on.
2 The countdown display and one of the wash cycle LEDs will be flashing.
3 Press and hold down the > button, then simultaneously press and release the Start button. Now release the >
button.
4 The "Sanitized" LED will be flashing. You are now in options mode.
5 Press the > button to select the option you would like to adjust.
To set amount of Rinse Aid:
Note: If your glasses have spots on them, you need more rinse aid. If your glasses have streaks on them, you need less
rinse aid.
1 Follow the above instructions to enter options mode.
2 With the display showing "r:00" - "r:06" press the < button to change the amount of rinse aid dispensed.
r:00 = rinse aid is OFF
r:03 = medium amount of rinse aid dispensed
r:06 = highest amount of rinse aid dispensed
3 Press Start to save your setting.
To turn Extra Dry Heat ON or OFF:
1 Follow the above instructions to enter options mode.
2 With the display showing "d:O0" or "d:01" press the < button to turn Extra Dry Heat ON or OFF.
d:O0= Extra Dry Heat is OFF
d:01 = Extra Dry Heat is ON
3 Press Start to save your setting.
12
To Next Page
Loading...
