To reinstall the bottom spray arm, return the bottom spray arm to the
installed position and press it until it snaps into place. Return the bot-
tom rack to the installed position.
Check and clean the filter system
The filter system consists of a Large Object Trap, Fine Filter and a Micro Filter.
The filter system is located on the inside of your dishwasher under the lower rack
and is easily accessible. Durin 8 normal use, the filter system is self-cleaning. You
should occasionally inspect it for foreign objects and clean it when necessary.
Fine
Filter
Large Object
Trap
Micro
Filter
To avoid injury, do not reach into the large object trap with your fingers.
The large object trap could contain sharp objects.
To remove the Large Object Trap, remove the bottom rack. Grasp the assembly and
turn it counterclockwise as shown in Figure 10. Lift the assembly out,
Carefully examine the assembly. If you find debris in the Large Object Trap, turn it
upside-down and gently tap it on a flat surface to dislodge and remove debris.
Flush the Micro Filter clean by holding it under running water.
To reinstall the filter system, return the fine filter to the installed position. Turn the
locking nut clockwise until it is locked. The arrow on the ring handle and the arrow on
the Fine Filter should point at each other.
Figure 10
Clean the exterior door panel
Colored doors: use only a soft cloth dampened with soapy water.
Stainless steel doors: use a soft cloth with a non-abrasive cleaner (preferably a liquid spray) made for cleaning
stainless steel. For the best results, apply the stainless steel cleaner to the cloth and then wipe the surface.
Clean the door gasket
Regularly clean the door gasket with a damp cloth to remove food particles and other debris. Also clean the door
seal, located inside the dishwasher at the bottom of the door.
Winterizing your unit
If your dishwasher will be unused for an extended period of time in a location that experiences freezing tempera-
tures (holiday home or through a vacation period), have your dishwasher winterized by an authorized profes-
sional service. Turn your household water supply to the dishwasher off when on extended vacation or when
dishwasher will not be used for more than 1 month.
Self Help
Dishwashers may occasionally exhibit problems that are unrelated to a malfunction of the dishwasher itself. The
following information may help you with a dishwasher problem without involving a repair professional.
Self-latching
door not closing
properly
Dishwasher does
not start
1. Self-latching feature will not work properly if
dishwasher is not installed correctly.
1. Ensure the alignment of the dishwasher frame is accurate and
level.
1. Door may not be properly latched
2. Unit may not be turned on
3. Unit not reset or previous cycle not completed
4. Delay start engaged
5. Interruption of electrical power supply to dish-
washer or blown fuse.
6. The door may have been closed without first
selecting a cycle
7. Water supply may not be turned on
1. Shut the door completely until you hear a click
2. Press the main power switch to turn unit on
3. To reset, refer to "Cancel a Cycle" on page 12 of this manual
4. To reset, refer to "Delay Start" section on page 12 of this manual
5. Check circuit breaker
6. Select a cycle and close the door.
7. Check and turn on water supply
14
To Next Page
Loading...
