Display does not
illuminate or con-
sole lights are
not on
Dishwasher
seems to run a
long time
Dishes are not
getting clean
enough
Dishes are not
getting dry
enough
Odor
Dishwashernot
filling with water
Water leaks
Tub stains
t. Afusemayhavebeenblownorcircuitbreakertripped
2. Doornot closed or latched
Note: For modelswith controls on top of the
door, the displayonly illuminate when the door is
opened and controls are visible.
1. Incoming water is not warm enough
2. Cycle time can vary due to soil and water conditions
3. Rinse agent dispenser is empty
4. Dishwasher connected to cold water supply
Note: Refer to "Wash Cycle Information" section
on page 22 ofthis manual for typical cycle lengths
1. Spray arm movement obstructed
2. Spray arm nozzlesclogged
3. Improper use of detergents
4. Filters could be clogged
5. Dishesare nested or loadedtoo close together
6. Selected wash cycle is not suitable for food
soilconditions
2. Rinse agent dispenser is empty
2. Improper loading of dishes
3. Selected cycle does not include drying
4. Extra Dry Heat is not activated
Note: Plastic or Teflon do not typically dry as well
as other items due to their inherent properties
2. Food debris is present at the bottom of the
dishwasher
2. Food particles are present near the door seal
3. Dishes left in unit too long before running a cycle
4. Residual water is present at the bottom of the
dishwasher
5. Drain hose is obstructed
1. Restriction in the water supply system
2. Previous wash cycle was not completed
3. Delay start is active
4. Household water supply turned off
1. Suds
2. Door seal could be pulled away from track
3. Condensation vent is blocked
4. Improper installation
1. Stains on the dishwasher interior are due to
water hardness
2. Silverware in contact with tub
1. Check the fuse or circuit breaker box and replace the fuse or
reset the breaker if necessary
2. Ensure door is properly latched and completely closed until you
hear it click
1. Before starting a cycle, run hot water faucet at the sink closest to
the dishwasher
2. Sensors in the dishwasher automatically increase the cycletime
to ensure a good wash when heavy soil is detected
3. Add rinse agent
4. Verify dishwasher isconnected to hot water supplyplumbing
1. Ensurethat spray arm movement is not blocked by hand rotating
spray arms before starting cycle
2. Removethe spray arms and clean accordingto the "Care and
Maintenance" section on page 13-14 of the manual
3. Increaseor decreasedetergent depending on the water hardness
(refer to Table 1 on page 10)
4. Clean the filters according to the "Care and Maintenance" sec-
tion on page 13-14 of the manual
5. Rearrange load such that water spraycan reach all items inthe
dishwasher- see "Loading the Dishwasher" section on page 6-7 of
the manual
6.Refer to "Wash Cycle Information" sectionon page11 of themanual
1. Add rinse agent - the use of rinse agent improves drying
2. Rearrange load to ensure itemsare not nesting (see "Loadingthe
Dishwasher"section on page 6-7 of the manual)
3. Rinseand Hold setting does not include drying
4. See the "Operating the Dishwasher"section on page 12-13 of
this manualto learn how to activate Extra Dry Heat
1. Remove the filters and clean according to the "Care and Mainte-
nance" section on page 13-14 of the manual
2. Referto "Care and Maintenance" section on page13-14 of the
manual
3. Run a Rinseand Hold cycle if you do not intend to immediately
wash the dishes
4. Ensurethe unit has completely drained from the lastcycle
5. Removeanyobstructions from the drain hose by callingqualified
personnel.
Note: If odor still persists, run the Normal/Regular cycle until it
flushes and interrupt the cycle and place an 8oz. cup of distilled
white vinegar solution on the top rack and then finish the cycle.
1. Ensure that the water supply valve (typically located under
kitchen sink) is open and check that the water supply line has no
kinks or clogs
2. Refer to the "Operating the Dishwasher" section on page 12-13
of the manual.
3. Cancel the delay start or wait until delay start time completes
4. Turn household water supply on
1. Wrong type of detergent results in sudsand leaks- use only dish-
washer detergents. If sudsstill persist, add one tablespoon ofvege-
table oil at the bottom of the dishwasherand run the desired cycle.
2. Ensurethe door seal is in the track
3. Ensurethat condensation vent is not blocked
4. Haveproper installation verified by qualified personnel (water
supply,drain system, leveling, plumbing)
1. Concentrated lemon juice can reduce the build up of hard water
stains. Run a Regular cycle until it flushes and interrupt the cycle
and then place an 8oz. cup of the concentrated lemon solution on
the top rack and finish the cycle, this can be done periodically to
avoid build up.
2. Ensure that silverware does not make contact with the tub while
running a cycle.
15
To Next Page
Loading...
