NL Troubleshooting
Malfunction Cause Troubleshooting
There are wipeable or
water-soluble deposits
in the interior or on the
door of the appliance.
2. Change the detergent if
necessary.
The softening salt reservoir is
▶ Turn the softening salt container
closed.not closed.
There is white, difficult Components of the
detergent are
deposited. This deposit
usually cannot be
removed chemically.
▶ Change from "dishwasher detergent"
→Page 26.removable deposits on
the crockery or the
interior or door of the
appliance.
▶ Clean the device mechanically.
Water hardness is set
incorrectly or water hardness
is higher than 50 °dH
(8.9 mmol/l).
▶ Set the water softening to the
water hardness or top up with
softening salt.
3in1 detergent,
biodetergent or eco-
detergent is
insufficiently effective.
▶ Set the water softening to the
water hardness and use
separate agents (quality
cleaning agent, softening
salt, rinse aid).
Detergent is dosed
too low.
▶ Increase the dose of the dishwashing
detergent or change "dishwasher
detergent" → Page 26.
Washing program too weak
chosen.
▶ Select a more powerful rinse program
mom.
→"Programs", Page 17
Tea or lipstick residue
on the dishes.
Washing temperature is too low.
▶ Select a program with a high
re wash temperature.
→"Programs", Page 17
Dishwasher detergent has been
dosed too low or is unsuitable.
▶ Use a suitable "dishwasher detergent"
share" → Page 26 and dose it
according to the manufacturer's
instructions.
Crockery has been pre-
cleaned too well. The sensor
system therefore opts for a
weak washing program.
Stubborn dirt cannot
be partially removed.
▶ Only remove coarse food residues
and do not pre-rinse the dishes.
46
To Next Page
Loading...
