Bosch SKE52M75EU - Page 42

en Troubleshooting
42
Fault Cause and troubleshooting
Detergent residue in
the appliance
Lid of the detergent dispenser is blocked by items of
tableware parts and will not open.
1. Arrange tableware in the top basket tableware so
the tab collecting tray is not obstructed by table-
ware.
→"Arrange tableware", Page30
Items of tableware are blocking the dispenser lid.
2. Do not place tableware or fragrance dispensers in
the tablet collecting tray.
The lid of the detergent dispenser is blocked by the
tab and will not open.
▶ Position the tab in the detergent dispenser cross-
wise, not vertically.
Tabs are used in the quick or short programme. Dis-
solving time of the tab is not attained.
▶ Select a more intensive Programme or use Powder
detergent →Page26.
Washing effect and dissolving performance are re-
duced after a prolonged storage time or detergent is
very lumpy.
▶
Change your detergent →Page26.
Water marks on
plastic parts.
Due to laws of physics droplet formation on plastic
surfaces is unavoidable. After drying water marks are
visible.
▶ Select a more intensive programme.
▶ Position tableware at an angle.
→"Arrange tableware", Page30
▶ Use rinse aid.
→"Rinse aid", Page25
▶ Set the water softening system higher.
Wipeable or water-sol-
uble coatings are
present inside the ap-
pliance or on the
door.
Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
▶
Change your detergent →Page26.
▶ Clean the appliance mechanically.
White coating is deposited in the appliance interior.
1. Set the water softening system correctly.
In most cases you will need to increase the setting.
2. Change your detergent if required.
Special salt dispenser is not screwed tight.
▶ Screw the special salt dispenser tight.