Bosch SMS4HCW19E - Rinse Aid System; Rinse Aid; Setting the Amount of Rinse Aid Added

deRinse aid system
Additional runtime in
minutes
6
2.Fill in the rinse aid up to the max
mark.
Additional water consumption
in liters
5
Additional consumption of electricity
in kWh
0.05
The consumption values given are
laboratory measurements according
to the currently applicable standard
and determined using the Eco 50°
program and the factory-set water
hardness value of 13 - 16 °dH.
Max
3.If rinse aid has overflowed, remove
it from the rinse tank.
11 Rinse aid system
Overflowing rinse aid can lead to
excessive foam formation during
the rinse cycle.
11.1 Rinse aid
4.Close the lid of the rinse aid
reservoir.
For best drying results, use rinse aid.
Use only household dishwasher
rinse aid.
aThe lid clicks into place with an audible click.
11.2 Setting the amount of rinse
aid added
Fill in rinse aid
When the rinse aid refill indicator
lights up, refill rinse aid. Use only
household dishwasher rinse aid.
1.The tab on the lid of the rinse aid
reservoir
press and lift.
If streaks or water stains remain on
the dishes, change the amount of rinse
aid.
1. press.
2.To open the basic settings,
3 seconds
press.
aThe display shows Hxx. a
The display shows .
2
3. Press repeatedly until
the display shows the factory-set
value r05.
4. Press repeatedly until the
appropriate amount of rinse aid
has been added.
– A low setting adds less rinse aid
to the wash cycle and reduces
streaks on the dishes.
1
28