Basic settingsde
basic
position
Display text
rc1
Selection
rc0 - rc2
Description
Remote start
→
"Remote Start ", page
41
enable or disable.
The following settings are
possible:
¡With the setting "rc0"
the function is permanently
deactivated.
¡With the setting "rc1"
The function can be
selected using the button.
→
"Activate Remote Start",
page 41
¡With the setting “rc2”
the function is permanently
activated.
This basic setting is only
available after you have
connected the device to the
Connected to the Home
Connect app.
→
"Home Connect",
page 40
Factory setting re Start with Reset changed settings to
factory defaults. The settings
must be made for initial
commissioning.
YES
Confirm with
1Factory setting (may vary depending on device type)
15.2 Change basic settings
3. Press repeatedly until the
display shows the desired setting.
Tip:Connect your device to a mobile
device. You can easily adjust all
settings using the Home Connect
app.
4. Press repeatedly until the
display shows the appropriate value.
You can change several settings.
5.To save the settings,
Press for 3 seconds.
1. press.
2.To open the basic settings,
3 seconds
press.
aThe display shows Hxx. a
The display shows .
39
To Next Page
Loading...
