What to do if water spots appear on garment during ironing with Bosch TDS60 Iron?
Water spots may appear because of steam condensed on the ironing board. Wipe the textile cover of the ironing board and iron any water drops to dry them.
What to do if the 'Water tank empty' indicator light (4) comes on Bosch Iron?
If the 'Water tank empty' indicator light comes on, it means the water tank is empty or not correctly fitted onto the appliance. Fill the water tank or fit it correctly.
Why does my Bosch TDS60 Iron make a pumping sound?
The pumping sound occurs because water is being pumped into the steam tank. If the sound does not stop, do not use the steam station and contact an authorised technical service centre. Also, the steam release button may have been activated for too long or pressed too frequently; use the steam release button at intervals.
What to do if dirt comes out through the soleplate of my Bosch TDS60?
Dirt may come out through the soleplate due to a build-up of limescale or minerals in the boiler and iron. Carry out a cleaning cycle (see the “Descaling process" section). Also, it may be caused by chemical products or additives being used. Never add products to the water (see the “Filling the water tank” section). Clean the soleplate with a damp cloth.
What to do if my ironed garment turns a dark colour and/or sticks to the soleplate of Bosch Iron?
If the ironed garment turns a dark colour or sticks to the soleplate, the selected temperature is too high and has damaged the garment. Select a suitable temperature for the material being ironed and clean the soleplate with a damp cloth.
Why does my Bosch TDS60 Iron begin to smoke when switched on?
When the iron is first used, certain components on the appliance have been lightly greased at the factory and may produce a small amount of smoke when initially heated. This is completely normal and will stop after a short while. During subsequent use, the soleplate may be soiled. Clean the soleplate according to the cleaning instructions in this manual.
Why does water flow through the holes on the soleplate of my Bosch Iron?
Water may flow through the holes on the soleplate because the water is condensing inside the tubes, especially if steam is being used for the first time or has not been used for a long time. Point the iron away from the ironing area and press the steam release button until steam is produced.
What to do if the “Calc'nClean” indicator light (3) does not turn off on my Bosch TDS60 Iron?
If the “Calc'nClean” indicator light does not turn off, the iron descaling process has been stopped before being completed. Restart and complete the iron descaling process.
Why does the hose get hot during use of my Bosch Iron?
It is normal for the hose to get hot during use. It is caused by the steam passing through the hose during steam ironing. Place the hose on the opposite side so that you do not touch the hose during ironing.
What to do if water leakage from the boiler of my Bosch TDS60?
Water leakage from the boiler is caused by Boiler cap (9) being loose. Tighten the cap.
To Next Page
General