10
Installation
TR2000T – 6 720 885 113 (2018/04)
5.3 Water connection
▶ Identify the piping for hot and cold water, in order to avoid
a possible swop ( Fig. 7 and 8).
Fig. 7 Installation above the sink
[1] Cold water inlet (right hand side)
[2] Hot water outlet (left hand side)
Fig. 8 Installation under the sink
[1] Cold water inlet (right hand side)
[2] Hot water outlet (left hand side)
▶ Use the appropriate connection accessories to do the
hydraulic connection to the appliance.
Fig. 9 Water connection
CAUTION: Damage to appliance
connections through contact corrosion!
▶ Use galvanized insulators in your water
connections. These will avoid galvanic
electric currents between the hydraulic
link metals and, consequently corrosion
of these.
NOTICE: Material damage!
▶ Install a filter at the water inlet in areas
where the water contains particles or
sediments.
It is recommended:
▶ to purge the system before appliance
installation, the existence of sand can
cause a reduction in flow or even cause a
total obstruction.
To Next Page
Loading...
Need help?
General
