5
Technical Characteristics and dimensions
Tronic 2000T – 6 720 885 113 (2021/08)
2 Technical Characteristics and
dimensions
2.1 Intended use
The appliance was designed to heat and store DHW. Comply
with all regulations and standards related to drinking water
applicable in the country.
Use the appliance only in closed systems.
Only use adequate solar liquid in the heat exchanger coil (if
present).
Using the appliance for any other purpose will be considered
incorrect use. Bosch accepts no liability for any damage
resulting from such use.
2.2 Appliance Description
• Steel-glassed tank in conformity with the European
regulations
• Tank designed and built to withstand high pressures
• Exterior material: steel sheeting and / or plastic
•Easy handling
• Insulating material: polyurethane without CFC
• Anticorrosion protection: magnesium anode.
2.3 Anticorrosion protection
The inside of the tank is lined with homogeneous glass enamel,
completely neutral with regards to compatibility and contact
with potable water. This lining is neutral with regard to the use
with potable water. The existence of a magnesium anode
provides additional anticorrosion protection.
2.4 Accessories (included in the appliance
packaging)
Fig. 1
[1] Hook (2x)
1)
[2] Sleeve (2x)
1)
[3] Safety valve (8 bar)
[4] Galvanic insulator (2x)
1)
Water characteristics Unit
Water hardness, min. ppm
grain/US gallon
°dH
120
7.2
6.7
pH, min. – max. 6.5 – 9.5
Conductivity, min. – max. μS/cm 130 – 1500
Table 2 Water characteristics
1) available in some models (depending on the market)
To Next Page
Loading...
