12
Use
Tronic – 6 720 816 255 (2018/06)
6Use
Fig. 11 User interface
[1] Indicator
[2] Temperature selector
6.1 Switching the appliance on/off
Turn on
▶ Connect the appliance via a socket with earth connection.
Turn off
▶ Disconnect the appliance from the electric current.
6.2 Setting the DHW temperature
The temperature of the water outlet can be regulated, on the
temperature regulator selector up to 65 °C.
Increasing the temperature
▶ Turn the temperature selector to the left.
Fig. 12 Increase the temperature
Decrease the temperature
▶ Turn the temperature selector to the right.
Fig. 13 Decrease the temperature
6.3 Draining the appliance
▶ Turn off the appliance from the electric supply.
▶ Switch off the water cutting valve and open a hot water tap.
▶ Open the safety valve (Fig. 14).
CAUTION: The electrical connection must
be done in accordance with the current
domestic electrical compliance installation
regulations.
Once the water has reached the selected
temperature level, the appliance stops
heating up (the indicator switches off).
When the water temperature is below the
desired value, the appliance re-starts the
heating cycle (the indicator switches back
on) until it reaches the desired temperature
selected.
DANGER: Burn risk!
Open a hot water tap to and verify the
temperature of the water in the appliance
before opening the safety valve.
▶ Wait until the water temperature
decreases in order to avoid burns or any
other damage.
To Next Page
Loading...
