EasyManua.ls Logo

Bosch VeroProfessional - Cleaning; Descaling

Bosch VeroProfessional
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
38
deen
Descaling
espresso Ë Í
service - DescaLe
i - button 3 sec.
The
start
button 8asheswhilethedifferent
descaling processes are running.
Theguresonthetoprightindicatethe
progress of the programme.
Hold the j button 7 down for at least 3
seconds.
DescaLe
start
Press the
start
button 8; the display 5 will
guide you through the programme.
eMpty Drip tray
r
epLace Drip tray
Empty drip tray 28 and replace.
pLace 0.5 L container unDer MiLk
Frother
start
Place a container with a capacity of 0.5
litres under the milk frother 10.
Press the
start
button 8.
Note: Ifthewaterlter33 is activated, the
displaywillpromptyoutoremovethelter
33, then press the
start
button 8 again
reMove FiLter
start
aDD 0.5 L Water anD DescaLer
start
Pour lukewarm water into the empty
water tank 11 up to the “0.5” litre mark
and dissolve 2 Bosch descaling tablets in
it.
Press the
start
button 8. The descaling
programme will now run for about 20
minutes.
DescaLing
not enough DescaLing
FLuiD. reFiLL FLuiD
Note: If there is not enough descaling
solution in the water tank 11, the
corresponding prompt is displayed. Pour in
descaling solution and press
start
8 again.
cLean anD reFiLL Water tank
start
Rinse the water tank 11andrellitwith
fresh water up to the “max” mark.
Press the
start
button 8. The descaling
programme now runs for about 1 minute
and rinses the appliance.
DescaLing
e
Mpty Drip tray
repLace Drip tray
Empty drip tray 28 and replace.
The appliance has completed descaling and
is ready for use again.
Cleaning
espresso Ë Í
service - cLean
i - button 3 sec.
The
start
button 8asheswhilethedifferent
cleaning processes are running.
Theguresonthetoprightindicatethe
progress of the programme.
Fill the water tank 11 up to the “max
mark.
Hold the j button 7 down for at least 3
seconds.
cLean
start
Press the
start
button 8; the display 5 will
guide you through the programme.

Table of Contents

Related product manuals