Bosch VitaPower 4 Series - Using programmes; Pushing down food for processing; Adding more ingredients; Emptying the blender jug

en Basic operation
36
1. Set the rotary switch to ⁠.
→Fig.
9
a The status display (LED) on the
rotary switch lights up.
2. Press the or
programme button.
→Fig.
12
a While the programme is running,
the LED for the selected pro-
gramme lights up and the status
display (LED) goes out.
3. Wait until the appliance stops.
4. Set the rotary switch to ⁠.
→Fig.
13
Tip:To prematurely stop the pro-
gramme, set the rotary switch to ⁠.
5. Empty the blender jug.
→"Emptying the blender jug",
Page36
7.6 Pushing down food for
processing
1. Remove the measuring jug and in-
sert the pusher into the filling
opening.
→Fig.
14
2. Push down the food from the sides
of the blender jug.
→Fig.
14
7.7 Adding more ingredients
1. During processing, remove the
measuring jug and add the ingredi-
ents through the opening in the lid.
→Fig.
15
2. To add larger quantities, set the
rotary switch to ⁠.
3. Wait until the appliance stops.
4. Turn the lid in the direction and
remove it.
→Fig.
16
5. Add the ingredients.
→Fig.
16
6. Place the lid on the blender jug
again and continue to process the
ingredients.
7.8 Emptying the blender jug
Requirement:The appliance has
stopped.
1. Turn the blender jug anti-clockwise
and remove it from the main unit.
→Fig.
17
2. To pour out just a portion of the
processed food, use the spout.
‒ Open the spout.
‒ Place the processed food in a
suitable container or serve im-
mediately.
‒ Close the spout.
→Fig.
18
3. To pour out all of the processed
food, remove the lid.
→Fig.
19
7.9 Processing food using
the To-Go blender jug
1. Prepare the food.
For example, cut large items of
food into pieces.
2. Add the food to the To-Go blender
jug.
→Fig.
20
Observe the minimum and max-
imum processing quantities.
→"Overview of recipes", Page39
3. Place the To-Go blade insert on
the To-Go blender jug.
→Fig.
20
4. Screw the To-Go blade insert and
the To-Go blender jug in tightly.
→Fig.
21
– The and markings must
match up.
– You can only connect the To-Go
blade insert to the main unit
when the To-Go blender jug is
screwed on fully.