Bosch VitaPower 4 Series - Cleaning the main unit; Cleaning the blender; Cleaning the To-Go blender jug and To-Go blade insert; Using the cleaning programme

en Cleaning and servicing
38
8.3 Cleaning the main unit
WARNING
Risk of electric shock!
An ingress of moisture can cause an
electric shock.
▶
Never immerse the appliance or
the power cord in water or clean in
the dishwasher.
▶
Do not use steam- or high-pres-
sure cleaners to clean the appli-
ance.
▶
Wipe down the main unit with a
soft, damp cloth.
8.4 Cleaning theblender
WARNING
Risk of cutting!
The blender knife has sharp blades.
▶
When cleaning and emptying the
blender jug, watch out for the
sharp blades.
▶
Never touch the edges of the
blades with bare hands.
ATTENTION!
The blender knife has sharp blades.
Improper handling may damage the
blades or the surface.
▶
Never set the blade insert down
with the blade facing downwards.
1. Remove the measuring jug.
→Fig.
28
2. Remove the lid.
→Fig.
28
3. Turn the blender jug anti-clockwise
and remove it from the main unit.
→Fig.
29
4. Turn the blender jug upside down.
5. Open the retaining bracket.
→Fig.
30
6. Remove the EasyClick blade insert
from the blender jug.
→Fig.
30
7. Clean the components.
8.5 Cleaning the To-Go
blender jug and To-Go
blade insert
ATTENTION!
The blender knife has sharp blades.
Improper handling may damage the
blades or the surface.
▶
Never set the blade insert down
with the blade facing downwards.
1. Turn the To-Go blade insert anti-
clockwise and remove it from the
To-Go blender jug.
→Fig.
31
2. Turn the lid anti-clockwise and re-
move it from the To-Go blender
jug.
→Fig.
32
3. Open the mouthpiece on the lid.
→Fig.
32
4. Remove the seal.
→Fig.
32
5. Clean the components.
8.6 Using the cleaning pro-
gramme
You can use the cleaning pro-
gramme to preclean the blender jug
and the blade insert.
Requirements
¡ The blade insert is installed.
¡ The blender jug has been attached
and locked.
¡ The blender jug is filled with clean-
ing fluid (700 g water + 1drops of
washing-up liquid).
¡ The lid is attached and locked.
¡ The rotary switch is set to ⁠.
1. Set the rotary switch to ⁠.
→Fig.
9
a The status display (LED) on the
rotary switch lights up.