Bosch WAJ Series - Changing the Programme; Cancel the Programme; Programme End During Rinse Hold; Programme End

en Operating the appliance
30
Changing the programme
1. Press the A button.
2. Select another program.
3. Press the A button.The new
program starts from the beginning.
Cancel the programme
For programs at high temperature:
1. Press the A button.
2. To cool down laundry: Select '
Rinse.
3. Press the A button.
For programs at low temperature:
1. Press the A button.
2. Select 0 Spin/Drain [//0 Spin/
Empty [.
3. Press the A button.
Programme end during rinse
hold
- - - - 0 appears in the display panel and
the indicator lamp of the A button
flashes.
Continue the program by:
■ Pressing the A button (the laundry
will be drained with the default spin
speed setting*) or
■ Selecting a spin speed or set the
program selector to 0 Spin/Drain
[//0 Spin/Empty [ and then
pressing the A button.
* depending on the chosen program ->
Overview of programmes
Programme end
End appears in the display panel and
the indicator lamp of the A button is
off.
Removing laundry/switching
off the appliance
1. Open the door and remove the
laundry.
2. Turn the program selector to off
position. The appliance is switched
off.
3. Turn off the tap.
Note: Not required for Aqua-Stop
models.
Notes
■ Always wait until the program ends,
as the appliance could still be
locked.
■ If the display panel goes off at the
end of a program, the energy-saving
mode is active. Press any button to
activate the panel.
■ Do not leave any items of laundry in
the drum.They may shrink in the next
wash or discolour another item.
■ Remove any foreign objects from the
drum and the rubber seal – risk of
rusting.
■ Wipe the rubber seal dry.
■ Leave the door and detergent
drawer open so that any residual
water can evaporate.