Bosch WAV28G43 - Programme Status and Child Lock; Resuming After Rinse Hold; Unloading Laundry and Powering Off; Childproof Lock Feature

en Childproof lock
36
– If the temperature is high, start
the Rinse/Freshen Up pro-
gramme.
– If the water level is high, start
the Spin programme or select a
suitable programme for draining.
→"Programmes", Page27
3. Remove the laundry.
→"Unloading the laundry",
Page36
13.12 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
¡ Rinse Stop is activated.
→"Buttons", Page25
¡ The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
1. Set the Spin programme or a pro-
gramme for draining the water.
→"Programmes", Page27
2. Press Start/Pause .
13.13 Unloading the laundry
1. Open the door.
2. Remove the laundry from the
drum.
13.14 Switching off the appli-
ance
1. Press .
2. Wipe the rubber gasket dry and re-
move any foreign objects.
3. Leave the appliance door and de-
tergent drawer open so that resid-
ual water can evaporate.
14 Childproof lock
Secure your appliance against being
operated unintentionally using the
controls.
14.1 Activating the childproof
lock
▶ Press and hold the two Kinder-
sicherung 3Sek. buttons for
approx. 3seconds.
a The display shows ⁠ .
a The controls are locked.
a The childproof lock remains active
even after the appliance has been
switched off and in the event of a
power failure.
14.2 Deactivating the child-
proof lock
Requirement:To deactivate the
childproof lock, the appliance must
be switched on.
▶ Press and hold the two Kinder-
sicherung 3Sek. buttons for
approx. 3seconds.