en HomeConnect
38
2. Follow the instructions in the
HomeConnect app.
15.3 Activating Wi-Fi on the
appliance
Note:When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
1. Press and hold Fernstart for ap-
prox. 3 seconds.
2. Select Wi-Fi On/Off.
3. Select on.
a Wi-Fi is activated.
Note:If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
15.4 Deactivating Wi-Fi on the
appliance
1. Press and hold Fernstart for at
least 3seconds.
2. Select Wi-Fi On/Off.
3. Select off.
a Wi-Fi is deactivated
Note:The connection is automatically
re-established when the Wi-Fi is
switched back on.
15.5 Resetting the appliance
network settings
1. Press and hold Fernstart for at
least 3seconds.
2. Select Network settings.
3. Select Reset.
a The network settings are reset.
15.6 Remote start
Enable the appliance for remote start
via the HomeConnect app.
Activating remote start
Notes
¡ Remote start is deactivated for
safety reasons in the following
circumstances:
– Open the appliance door.
– Press Start/Pause .
– Press Fernstart.
– Switch off the appliance.
– Following a power cut.
¡ For safety reasons, remote start
cannot be activated if the appli-
ance door is open.
Requirements
¡ The appliance is connected to your
Wi-Fi home network.
¡ The appliance is connected to the
HomeConnect app.
¡ A programme is selected.
▶ Press Fernstart.
If you press and hold the button
for at least 3seconds, the
HomeConnect menu opens.
If you briefly press the button, the
appliance is enabled for remote
start via the HomeConnect app.
If you open the appliance door, the
function is automatically deactiv-
ated.
a Fernstart lights up.
Note:To deactivate the function,
press Fernstart.
15.7 Remote diagnostics
Customer Service can use Remote
Diagnostics to access your appliance
if you contact them, have your appli-
ance connected to the HomeCon-
To Next Page
Loading...
