18 | English
1 609 929 X41 | (28.10.10) Bosch Power Tools
Technical Data
Assembly
Inserting/Replacing the Battery
Using alkali-manganese or rechargeable batteries is recom-
mended for operation of the measuring tool.
To open the battery lid 10, press the latch 12 in the direction
of the arrow and fold up the battery lid. Insert the supplied bat-
tery. Pay attention that the polarity is correct, according to the
representation on the inside of the battery lid.
When the battery low indicator k lights up on the display,
measuring is still possible for approx. 1 hour when using alkali-
manganese batteries (lower battery service life for rechargea-
ble batteries). When the battery low indicator k flashes, meas-
uring is possible for approx. 10 minutes. When the battery low
indicator k and the illuminated ring 1 (red) flash, measuring is
no longer possible and the battery/rechargeable battery must
be replaced.
Digital Detector PDO Multi
Article number
3 603 K10 000
Maximum scanning depth*:
–Ferrous metals
– Non-ferrous metals (copper)
– Copper conductors (live)**
– Wood
80 mm
60 mm
40 mm
20 mm
Automatic switch-off after approx.
5 min
Operating temperature
–10 °C ... +50 °C
Storage temperature
–20 °C ... +70 °C
Battery
1 x 9 V 6LR61
Battery
1 x 9 V 6F22
Operating lifetime
(alkali-manganese batteries) approx.
6h
Weight according to
EPTA-Procedure 01/2003
0.25 kg
* depends on material and size of objects as well as material and condi-
tion of structure
** less scanning depth for wires/conductors that are not “live”
f In terms of accuracy, the measuring result can be inferior in case
of unfavourable surface quality of the base material.
Please observe the article number on the type plate of your measuring
tool. The trade names of the individual measuring tools may vary.
OBJ_BUCH-139-002.book Page 18 Thursday, October 28, 2010 9:38 AM
To Next Page
Loading...
