Bosch ISC-BPR2-WP12 - User Manual

© 2014 Bosch Security Systems, Inc. F.01U.140.812 | 08 | 2014.11 | 1
NOTE:
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
UL/C-UL
Perform Walk Test at least once a year.
Pet immunity not tested by UL/C-UL.
Use only a Listed limited-power source.
The Listed control unit or a Listed burglary power supply must provide 4
hours (40 mAh) of standby power.
Install the unit in accordance with National Electrical Code NFPA 70 and
Part 1 of the Canadian Electrical code CSA C22.1.
Sluit alle bedrading uitsluitend aan op een
circuit met een extra lage veiligheidsspanning.
Prenez soin de connecter tous les câbles à un
circuit à très basse tension de sécurité (TBTS).
Alle Drähte sind ohne Ausnahme an
Niederspannung anzuschließen.
Collegare tutti i cavi esclusivamente a un circuito
SELV (circuito di sicurezza a bassissima tensione).
0 - 95% Relative Humidity
(0 - 85% UL/C-UL installations)
-30°C to +55°C
(-20°F to +130°F )
UL Listed installations,
the temperature
range is 0°C to +49°C
(+32°F to +120°F)
Pour les installations
certiées NFA2P,
Température de
fonctionnement
-10°C à +55°C
Changes or modications not expressly approved
by Bosch Security Systems, Inc. can void the
user’s authority to operate the equipment.
Optional Brackets:
B328, B338, B335
EN 50131-2-2 Grade 2
EN 50130-5 Environmental Class II
IP30 IK04 (EN 60529, EN 62262)
Conecte el cableado únicamente a un circuito
de seguridad para voltajes muy bajos (SELV).
INCERT B-509-0051/b
Ligue todas as cablagens apenas a um
circuito de segurança de tensão extra baixa
(SELV).
Certicat NF A2P 2620200001-B0
en Installation Guide
2 boucliers NF324 - H58
Autosurveillance à l’ouverture
Immunité champ magnétique
Test sans masque de vision verticale
et sans immunité aux animaux
www.afnor.org
www.cnpp.com
För svensk installationsanvisning se www.boschsecurity.se.
2
1
1 2 3
4
2,2 m - 2,75 m
(7.5 ft - 9 ft)
Recommended:
2,2m (7.5 ft)
Pet Friendly
≤ 20 kg (45 lb)
Blue Line Gen2
Pet Friendly PIR
Motion Detector
ISC-BPR2-WP12

Summary

Installation Guide Overview

FCC Compliance and Interference Prevention

Details FCC rules for Class B digital devices and measures to mitigate radio interference.

UL;C-UL Installation and Power Requirements

Specifies UL/C-UL requirements including walk tests, power sources, and electrical code compliance.

European and International Safety Standards

Lists EN standards, environmental class, protection ratings (IP/IK), and operating temperature/humidity.

Wiring and Power Specifications

Power Input and Current Draw

Details the DC voltage range, standby, and alarm current consumption for the device.

LED Indicator and Mode Settings

Explains the function of the LED indicator and how to enable/disable it for different applications.

Detection Zone and Range

Motion Detection Pattern

Illustrates the detection pattern, coverage area, and maximum range of the PIR motion detector.

Bosch ISC-BPR2-WP12 Specifications

General

Type	PIR Motion Detector
Material	Plastic
Color	White
Field of View	90°
Detection Range	12 meters
Power	Battery or wired
Operating Voltage	9 VDC to 15 VDC
Current Consumption	15 mA
Operating Temperature	-20 °C to +50 °C