Why is my Bosch WGG244FCGB not cleaning clothes properly?
Insufficient cleaning in your Bosch Washer may be because the basic dosage is not adjusted. If intelligent dosing is activated, adjust the basic.
What to do if my Bosch WGG244FCGB door cannot be opened?
If you can't open the door of your Bosch Washer, it might be because the temperature is too high (wait until it has dropped), the water level is too high (select a suitable programme for draining), or there's a power failure (open the door using the emergency release).
Why is water leaking from the inlet hose of my Bosch WGG244FCGB Washer?
If water is leaking out at the water inlet hose of your Bosch Washer, it means that the water inlet hose is not correctly or securely connected. Connect the water supply hose correctly and tighten the screw connection.
Why water is not flowing in my Bosch Washer and detergent is not being dispensed?
If water isn't flowing into your Bosch Washer and detergent isn't being dispensed, it could be due to blocked filters in the water inflow (clean the filters); the tap being turned off (turn on the tap); or a kinked or jammed water inlet hose (ensure it's not kinked or jammed).
Why is the spin result not satisfactory in my Bosch WGG244FCGB?
If the spin result isn't satisfactory and the laundry is too wet or damp in your Bosch Washer, it could be because a low spin speed is selected (set a higher spin speed next time), or the unbalanced load detection system has interrupted the spin cycle (redistribute the laundry in the drum).
What to do if water is leaking from the outlet hose of my Bosch WGG244FCGB?
If water is leaking out at the water outlet hose of your Bosch Washer, it indicates that the water outlet hose is damaged. Replace the damaged water outlet hose.
Why do damp stains form on fabrics after Iron Assist programme in my Bosch Washer?
Damp stains may form on fabrics after the end of the Iron Assist programme in your Bosch Washer because water droplets from the drum or from the door have moistened the fabrics (iron the fabrics or hang them up to dry), or dirt on the door or seal causes leaks (clean the door and the seal).
Why is my Bosch Washer not draining water?
The water may not be draining from your Bosch Washer because the drain pipe or water outlet hose is blocked (clean the drain pipe and the water outlet hose); the drain pipe or water drain hose is caught or jammed (ensure that they are not kinked or trapped); the water outlet hose is connected too high (install the water outlet hose at a maximum height of 1 metre); the pump cover is not correctly assembled (correctly assemble the pump cover); the detergent dosage is too high (mix one tablespoon of fabric softener with 0.5 litres of water and pour the mixture into the compartment for manual dosing, but not for outdoor clothing, sportswear or items stuffed with down); if intelligent dosing is activated, reduce the basic; if you dose manually, reduce the amount of detergent for the next washin...
How to fix detergent residue on damp washing in my Bosch WGG244FCGB?
Detergent residue on damp washing in your Bosch Washer may be due to unsuitable detergent added to the dispenser of the intelligent dosing system (check whether the detergent used is suitable, drain the dispenser, clean it, and refill it), or the basic dosage not adjusted (if intelligent dosing is activated, reduce the basic).
What does error code E:10 mean on my Bosch WGG244FCGB?
The error code "E:10 / -00 / -10 / -20" on your Bosch Washer indicates that the pump for the intelligent dosing system is blocked. To resolve this: 1. Switch off the appliance. 2. Clean the pump unit. 3. Switch the appliance on. If the display appears again after cleaning the pump unit, or the programme cannot be started, call customer service.
To Next Page
General
