Why is my Bosch WGG244MH0 Washer not draining?
If your Bosch washer isn't draining, it could be due to a blocked drain pipe or water outlet hose, so clean them. Also, make sure the drain pipe and water drain hose aren't kinked or trapped. Another possible cause is that the water outlet hose is connected too high; install it at a maximum height of 1 metre.
What to do if my Bosch WGG244MH0 Washer programme does not start?
If the program on your Bosch washer isn't starting, make sure the mains plug of the power cord is plugged in and check the circuit breaker in the fuse box. Ensure there hasn't been a power cut by checking if other appliances are working. Also, verify that you have pressed Start/Nachlegen and that the door is fully closed.
Why is the spin result not satisfactory on my Bosch Washer?
If the spin result on your Bosch washer isn't satisfactory and the laundry is too wet, it could be due to too much detergent or fabric softener in the detergent drawer; observe the marking in the detergent drawer when dosing. Also, a low spin speed may be selected, so set a higher spin speed for the next wash cycle. The load might also be too large, so reduce the amount of laundry next time. Finally, ensure you're using a suitable program for the type of fabric.
What to do if the display goes out and Start/Nachlegen flashes on my Bosch WGG244MH0 Washer?
If the display of your Bosch washer goes out and the Start/Nachlegen button flashes, it means the energy-saving mode is active. Simply press any button to exit this mode.
What does E:60 / -2B mean on my Bosch WGG244MH0 and how to fix it?
The error code E:60 / -2B on your Bosch washer indicates that the unbalanced load detection system has interrupted the spin cycle because the laundry is unevenly distributed. Try redistributing the laundry in the drum. Other potential causes include low water pressure (no action possible), a blocked filter in the water inflow (clean the water inflow filter), a turned-off tap (turn on the tap), or a kinked or jammed water inlet hose (ensure it is not kinked or jammed). If none of these steps resolve the issue, the water level measurement system may be defective, requiring after-sales service.
What to do if Bosch Washer displays E:35 / -10?
If your Bosch Washer displays the error code E:35 / -10, there is likely water in the base trough, or the appliance is leaking. Turn off the water tap immediately.
General| Category | Washer |
|---|---|
| Model | WGG244MH0 |
| Capacity | 9 kg |
| Spin Speed | 1400 rpm |
| Energy Efficiency Class | A+++ |
| Color | White |
| Loading type | Front Load |
| Dimensions (H x W x D) | 84.8 cm x 59.8 cm x 59 cm |
| Weight | 72.0 kg |
| Programs | 15 |
| Noise Level (Spinning) | 72 dB |
To Next Page
