Positioning and connecting en
21
2. Insert all four sleeves.
a) Clip the mains cable securely in
the holders.
b) Insert and tighten the screws.
c) Clip the hoses securely in the
holders.
Before switching on the appliance
again:
Notes
■ The support struts must be
removed.
~ "Removing the support struts"
on page 16
■ The transport braces must be
removed.
~ "Removing the transport locks"
on page 14
■ Pour approx. 1 litre of water into
dispenser II, select the Drain
programme and start.
This will prevent detergent from
flowing straight into the drain during
the next wash.
To Next Page
Loading...
