Bosch WNA14490GB - Appliance Settings; Adjusting Volume and Drum Care Signal

Appliance settings en
39
Removing laundry/switching
off the appliance
1. Set programme selector to Off.
2. Open the door and remove the
laundry.
3. Turn off the water tap.
Note: Not required for Aqua-Stop
models.
Notes
■ Do not leave any items of laundry in
the drum. They may shrink in the
next wash or discolour another item.
■ Remove any foreign objects from the
drum and the rubber seal – risk of
rusting.
■ Wipe the rubber seal dry.
■ Leave the door and detergent
drawer open so that any residual
water can evaporate.
■ Always wait until the programme
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.
Q Appliance settings
Appliance settings You can change the following settings:
■ The volume of the end signal.
■ The volume of the button signal.
■ Switching the drum care information
signal on/off.
You will need to activate the setting
mode in order to change these settings.
Activate setting mode:
1. Set the programme selector to
position 1. The appliance is switched
on.
2. Touch and hold the 0 Spin Speed
button and, at the same time, turn
the programme selector clockwise to
position 2. Release the 0 Spin
Speed button.
The setting mode is activated and the
preset setting appears in the display
panel.
Changing the volume and drum care
information
Use the ñ Finish in/ Time Dry button to
change the following settings at the
corresponding programme selector
positions:
■ 2: The volume of the end signal.
■ 3: The volume of the button signals.
1/2/3/4... positions on the
programme selector
0 = off, 1 = quiet,
2 = medium, 3 = loud,
4 = very loud