Cleaning and maintenance en
43
The drain hose at the siphon
is blocked
1. Turn the programme selector to Off.
Pull out the mains plug.
2. Loosen the hose clamp. Carefully
remove the drain hose; residual
water may leak out.
3. Clean the drain hose and siphon
connecting piece.
4. Re-attach the drain hose and secure
the connection point using the hose
clamp.
Filter in the water supply is
blocked
Release water pressure in the supply
hose:
1. Turn off the water tap.
2. Select the Cottons (activate
( SpeedPerfect setting)
programme.
Note: If your appliance with
intelligent dosing system
*
, you also
need to deactivate the intelligent
dosing system.
3. Select the A Start/Reload button.
Allow the programme to run for
approx. 40 seconds.
4. Turn the programme selector to Off.
5. Pull out the mains plug.
Clean the filters:
1. Disconnect the hose from the rear of
the appliance.
2. Use pliers to remove the filter.
3. Clean the filter with a small brush.
4. Connect the hose and check for
leaks.
* Depending on the model
To Next Page
Loading...
