Step8
ConnectDuctSystemtoDryer.
(ModelWTA3500Onlyl)
Connect the exhaust ducting system to the dryer
exhaust outlet.
Step 9
Final Check List
1. Review the electrical requirements (and for WTL
model the exhaust requirements) and steps 1
through 8 to make sure they were performed
properly.
2. Make sure the electricalsupply is on.
3. Read the Use & Care manual to fully understand
how your dryer operates. Turn on the dryer.
Select the "Heated Dry" cycleand let the dryer
run for 2-5 minutes.
4. After 2-5 minutes stop the dryer and open the
door. You shouldfeel heat inside the dryer.
5. If the dryer does not operate, refer to the SELF-
HELP and the SERVICE and REPAIR sections of
the Use and Care Manual.
6. Upon completing check, turn dryer off.
7. LEAVE INSTALLATION INSTRUCTIONS AND
USE and CARE MANUAL WITH OWNER.
10
To Next Page
Loading...
