4) Lift up the outer door glass and rotate it 90º clockwise. Don’t
rotate the outer door frame.
5) Reassemble all parts in the same position and order they were
disassembled (inner ring, glass bowl, inner frame) – when
reassembly is completed, the hinge will be rotated 180º.
Be sure to reinstall the single screws under the latch and hinge cover
plates.
90º
6) Move latch (to left side) and reassemble door latch cover.
7) Remove (left side) front panel latch cover by removing two (2)
screws.
702_58300000143767_ara_en_a Page 19 of 33
To Next Page
Loading...
Need help?
General