Repairs
2013-10-23 / DIS 113_58300000133444_ara_en_l Repair Instructions Laundry Repair Instruction;T22 Page 23 of 35
6.3 Replacing motor
Graphic 7: Motor
1 Electrical connection 4 Wheel
2 Motor shaft 5 Motor support
3 Tension spring
Prerequisite:
• Worktop has been removed.
• Right side panel has been removed.
• Drive belt has been removed.
6.3.1 Removing motor
1. Remove electrical connections from the motor (1) and protect against damage.
2. Remove module housing cover (process air).
3. Remove process air duct.
4. Secure motor shaft (2) using a wrench.
5. Turn fan roller (process air) to the left and remove.
6. Detach tension spring (3).
7. Remove screws.
8. Take motor out of the appliance.
6.3.2 Installing motor
Ensure that the drive belt is fitted correctly! Always observe the gap
between the pulleys.
► Install motor in reverse sequence.
To Next Page
Loading...
