5
English
2.2.2 Make an allowance for the wiring
1. Consider how the amplifier wires will thread into the bracket.
• To use the rear opening on the bracket, be sure to
insert the wires first, before you mount the bracket.
• To use the bottom opening, remove the plug from that
opening. Insert the wires through that opening after the
bracket is attached.
2. Insert and tighten the screws to secure the bracket to the
wall or ceiling.
2.2.3 Steps for adding a safety cable
To add a safety cable, if it is required by local code, follow these
steps:
2.2.3a
2.2.3b
.
25"Ø
0.625 cm
0.625"
1.58 cm
Installation
To Next Page
Loading...
