3
1.0 Before You
Begin
Thank you for purchasing the Bose
®
402
TM
C or 802
®
C
II systems controller.
In this owner’s guide, sections two and three list
safety, general descriptions, and main features for
both controllers. Section four shows examples of
complete systems in some typical applications. The
remaining section describes basic controller hook-
up. It also gives general electrical and operating
instructions.
See Appendix A for how to install the Acoustic Wave
®
Cannon
TM
System II speaker option card (OC-1). It is
important that the OC-1 be installed by authorized
Bose personnel. Appendix B gives the electrical and
mechanical specifications of the 402C and 802C II
systems controllers. Appendix C gives warranty and
service information.
2.0 Safety
Information
Please read this safety information before you
install, connect, or operate the Bose 402C or 802C II
systems controllers.
2.1 Read the instructions. Read and then keep all
safety and operating instructions for future reference.
2.2 Follow cautions. For your safety, follow all
cautions and warnings in the Owner’s Guide and on
the controller.
2.3 Avoid moisture. Never expose the controller
to water or excessive humidity. Do not install near
swimming pools, spas, or in other very humid
environments.
2.4 Avoid heat. Do not use the controller near
excessive heat sources. These include radiators,
heat registers, flood lamps, spotlights, stoves, and
other appliances.
2.5 Protect cables. Always route cables to keep
them from being pinched or cut by heavy or sharp
objects.
2.6 Connect the ground wire. Make sure you
properly connect the ground pin (if included) on
the power cord of the controller. It connects to the
ground of the power mains.
2.7 Vent the system. Properly vent the controller
if you mount it in a rack with other electronic
equipment. Vent the rear of the rack to prevent
excessive heat build-up.
2.8 If damage occurs. Refer servicing to qualified
service personnel under the following conditions:
A. If liquid spills into the unit.
B. If the unit is exposed to rain or water.
C. If the unit does not operate normally, even
though you have followed the instructions in this
manual.
D. If the unit exhibits a distinct change in
performance.
2.9 Check for safety. Following service or repairs,
ask the service technician to perform safety checks.
This includes proper connection of the ground wire
from the controller to the power mains.
To Next Page
Loading...
Need help?
General
