Need help?Do you have a question about the Bose 802C and is the answer not in the manual?
General| Weight | 5 lbs (2.3 kg) |
|---|---|
| Compatibility | Bose 802 Loudspeaker System |
| Functions | Equalization, Crossover, Limiting |
| Equalization | Specifically tailored for the Bose 802 loudspeaker system |
| Signal-to-Noise Ratio | >90 dB |
| Power Requirements | 100-240 V, 50/60 Hz |
| Input Impedance | 20 kOhms (balanced) |
| Dimensions | 1.75" H x 19" W x 7.8" D (4.4 cm x 48.3 cm x 19.8 cm) |
Procedure to perform a leakage current hot check on the unit's electrical connections.
Procedure for performing an insulation resistance test to ensure safety.
Instructions for removing the top cover to access internal components.
Instructions for reattaching the top cover after servicing.
Procedure for removing the 302EQ 'piggy-back' printed circuit board.
Procedure for installing the 302EQ 'piggy-back' printed circuit board.
Instructions for removing the main printed circuit board (PCB).
Instructions for installing the main printed circuit board (PCB).
Verifies the correct operation of the mode select and LED indicator functions.
Tests the frequency response when the unit is configured for 802 Full Range operation.
Tests the frequency response for the 302 Passive mode of operation.
Tests the frequency response in the Bi-Amp mode using specific output configurations.
Measures the total harmonic distortion across different operational modes.
Evaluates the unit's noise levels under specified test conditions.
Steps to convert a 220 Volt unit to operate on 110 Volt power.
Steps to convert a 110 Volt unit to operate on 220 Volt power.
To Next Page
