Using the Headset
20 - English
Using the headset with a Bluetooth
®
device
Pairing the first device
1. Press to turn on the headset.
2. Make sure the Secondary Audio Mode selector is in the MUTE or MIX position
(not OFF).
MUTE MIX
The power indicator glows green or yellow, depending on the charge level of
the battery. (If the light is red, the battery is low and needs replacing.)
The Bluetooth indicator flashes purple to indicate that the headset is in pairing
mode.
Note: The first time you turn on the headset, it will automatically go into
pairing mode and the Bluetooth indicator will flash purple. This will only
happen the first time you turn on the headset.
3. Locate the Bluetooth menu on your device and make sure the Bluetooth
feature is ON.
4. Select Bose A20 from the Bluetooth device list.
Bose A20
The Bluetooth indicator flashes blue while the devices are pairing, and a tone
indicates successful connection.
Note: After five minutes of inactivity, the headset will automatically exit pairing
mode and the Bluetooth indicator will turn off. To turn the Bluetooth
feature back on, press
.
Note: Each time you turn on the Bluetooth feature, the headset will attempt
to reconnect with the two most recently connected Bluetooth devices.
If the device(s) are turned off, or out of range, the headset will return to
pairing mode after five minutes. See “Reconnecting to a previously con-
nected device” on page 23.
To Next Page
Loading...
Need help?
General
