Using the Headset
English - 23
Reconnecting to a previously connected device
Each time you turn on the Bluetooth feature, the headset will attempt to reconnect
with the two most recently connected Bluetooth
®
devices.
1. Turn the headset on.
2. Make sure the Bluetooth indicator is flashing blue. If not, press
.
The indicator flashes blue.
3. To confirm connection, check the Bluetooth device list on your device.
Recovering a lost connection
If a connected Bluetooth device moves out of range, the connection will be lost.
The headset will automatically attempt to reconnect.
If the headset is unable to reconnect, it will go back into pairing mode. After five
minutes of inactivity, the Bluetooth feature will turn off. Move the device back into
range, and press
once to reconnect.
Disconnecting a Bluetooth device
• On the headset, press and hold for 5 seconds to turn the Bluetooth feature
off.
• On your device, turn the Bluetooth feature off.
• Move the Secondary Audio Mode selector to the OFF position.
Clearing the headset pairing list
With the Bluetooth feature on (Bluetooth indicator flashing), press and
hold
and at the same time for seven seconds. The headset will return to
pairing mode.
Controlling Bluetooth volume
Use the Bluetooth volume controls on the right side of the control module to
control the volume of a connected Bluetooth device.
Volume
down
Volume
up
• Each press increases or decreases the volume by one level.
• Press and hold the volume button to change the volume continuously.
To Next Page
Loading...
Need help?
General
